IceCap Heater Controller

ICECAP

IceCap

SKU IC-ACH1000W

In stock

$69.29
Where to Buy
Aquarium Heater Controller
Available in Stores

Description / IceCap Heater Controller

Aquarium Heater Controller

The IceCap heater controller can connect up to two heating elements (sold separately) and provides precise temperature control for an aquarium. It includes dual-heating power jacks and supports up to 1000 watts. For added safety, you can use it in conjunction with an aquarium system controller.

Features

  • Dual grounded output heater control
  • Accommodates a combined total of 1000 watts
  • Accurate heat control
  • For freshwater and marine aquariums
  • 1-year limited warranty

Specifications

Temperature Control Modes: On/Off Control, Heating
Temperature Control Range: 20-34°C / 68-93°F
Temperature Resolution: 0.1°C / 32°F
Temperature Accuracy: ±1°C  / ±1°F 
Ambient Temperature: <35°C / 95°F
Audible Alarm: Over Temperature Alarm
Input Power: 100 ~240VAC/60Hz
Relay Contact Capacity: Heating (10A, 100-240VAC)
Controller Body Dimensions: 3.125in x 5.375in x 1.125in (LxWxH)
Probe Cord Length: 5ft
Heater Outlet Cord Length: 18in 
Calibration Offset: ± 5.0° (C/F) in 0.5° increments

Heater controller only - Requires a proper-sized heater(s) to operate.
For Indoor use only

IC_HeaterControllerDiagram

Blue <POWER> LED indicates power ON
Red <ON/OFF> LED indicates heater power is ON

Button Functions

PowerSetButton

Hold and press the <SET> button for 5 sec. to switch the Controller ON or OFF. Press <SET> button once to enter the target temperature setting mode.

CF_Button

Press the <C/F> button to switch the display between Celsius and Fahrenheit.

PlusButton

Press the <+> button to increase the Target Temperature and press the <SET> button to save your setting.

Minus-Button

Press the <-> button to decrease the Target Temperature and press the <SET> button to save your setting.

Controller Temperature Calibration

Check the aquarium's water temperature on the thermometer against the temperature shown on the Heater Controller. If there is a large difference between the thermometer and the Heater Controller, you must calibrate it. 

  1. Press and hold <+> and <-> buttons simultaneously for around 3 seconds. The Water Temp display will begin blinking.  The original allowance value shows at 0.0. 
  2. Press <+> or <-> button to adjust up or down the value ± 5.0° (C/F) in 0.5° increments
  3. Finally, press the Set button to confirm calibration setting. The bottom display will change back to show the water temperature
Write Your Own Review
You're reviewing: IceCap Heater Controller
Your Rating:
Price
Value
Quality
loader
Loading...

You submitted your review for moderation.

This form is protected by reCAPTCHA - the Google Privacy Policy and Terms of Service apply.